OPTIFLUX 2050

Electromagnetic flowmeter for basic water and wastewater applications

  • Liner materials resistant to low concentrated chemicals
  • With extra isolation of electronics for use in high humidity areas
  • Flange: DN25…1200 / 1…48", max. PN40 / ASME Cl 300
  • 4…20 mA, pulse, frequency, status, HART®, Modbus

OPTIFLUX 2050

Electromagnetic flowmeter for basic water and wastewater applications

  • Liner materials resistant to low concentrated chemicals
  • With extra isolation of electronics for use in high humidity areas
  • Flange: DN25…1200 / 1…48", max. PN40 / ASME Cl 300
  • 4…20 mA, pulse, frequency, status, HART®, Modbus

Overview

The OPTIFLUX 2050 is an electromagnetic flowmeter (EMF) for basic water and wastewater applications. It is suitable for all cost-effective measurements where extremely high accuracy, extensive diagnostics or a wide range of communication options are not a priority. The EMF has a wide diameter range (DN25…1200 / 1…48") and all drinking water approvals. The extra isolation of the electronic device and housing makes this EMF particularly suitable for use in areas with extreme humidity.

The OPTIFLUX 2050 features a full bore design with wear resistant liner materials. Installation in measurement chambers subject to (constant) flooding is possible with the IP68 / NEMA 6P rated version. The EMF comes with current output (incl. HART®) or active pulse/frequency output and Modbus. A full on-site verification of the OPTIFLUX 2050 without process interruption can be carried out using the OPTICHECK service tool.

Product features and options depend on device configuration: Contact us to make sure that your preferred functionality can be combined in one device.

  • Bi-directional flow measurement over a wide dynamic range
  • Tropicalized electronics for use in areas with extreme humidity and chances of flooding
  • Standard wet calibration
  • PP or hard rubber liner: excellent chemical resistance
  • Also available in customer specific constructions
  • Signal converter with display or as blind version
  • Tamper proof
  • Full bore design: No moving parts, no wear, no pressure loss
  • Meets potable water standards: ACS, DVGW, NSF, TZW, WRAS etc.
  • On-site verification of flowmeter with OPTICHECK service tool

Related products

IFC 050

Electromagnetic flow converter for combination with OPTIFLUX and WATERFLUX flow sensors

  • Compact and wall-mounted housing (with or without display)
  • With sensor and process diagnostics for basic requirements
  • 4-wire, 1 x 4…20 mA, pulse, frequency, status, HART®, Modbus etc.

OPTIFLUX 2000

Electromagnetic flow sensor for combination with IFC 050, IFC 100 and IFC 300 signal converters

  • Full bore design: pipe cross-section without restrictions
  • Connection sizes: DN25…1200 / 1…48"
  • Liner: PP, PO or hard rubber
Email
Contact